9
8
Lamp Module
Installing the Lamp Module
When the console’s alarm trips, lamps connected to Lamp Modules set to the same
House Code as the console flash on and off. The lamps stop flashing and remain on
after about 4 minutes or when STOP is pressed on the Pendant Remote.
• Set the House Code dial to match the House Code set on the Personal Assistance
Console.
• Set the Unit Code dial to an unused code which can be controlled from a remote or
plug-in controller as required.
• Plug a lamp into the Lamp Module and plug the Lamp Module into a convenient AC
outlet, preferably an unswitched one to ensure that the lamp will always operate when
the alarm is triggered.
Local control
The Lamp Module includes circuitry to sense the lamp’s own on/off switch to turn the
lamp on locally. To switch a lamp on, turn the lamp’s own switch off then on again.
Installation
Installation
Home Automation Remote
Installing the Home Automation Remote
The X10 Home Automation Remote works with your Personal Assistance Console to let
you control lamps and appliances anywhere in the home.
Just set the House Code dial to the same House Code as the Personal Assistance
Console and you're ready to go.
Using the Home Automation Remote
To switch on a lamp or appliance, press the left side of the numbered key that matches
the Unit Code on the X10 module being controlled. Press the Bright and Dim keys to
adjust the brightness of lamps connected to Lamp Modules or Wall Switch Modules.
Move the slide switch to “9-16” to control modules with unit codes 9-16.
9-16
1-8
ON
OFF
A
C
E
G
I
K
M
O
.
.
.
.
.
.
.
.
1
2
3
4
5
6
7
8
Lamp Module
A
I
E
M
O
C
G
K
1
9
5
13
15
3
7
11
UNIT
HOUSE
