31
30
Special Notes
Intercom Systems
Intercom systems which send voice
signals over existing electrical wiring
might interfere with the ability to control
modules from your
Monitor Plus
security
system with the intercom in use. If the
intercom system has its own separate
wiring it will not cause a problem.
Arming
The ARM button on the Console arms
the system in the delay mode only. Use
a Remote Control if you want to arm
the system in the instant (MIN) mode.
Outdoor Infrared Motion Sensor
The Outdoor Motion Sensor (Model
PR511) will not trigger the
Monitor Plus
security system. It can, however, control
the same lights that the security system
controls.
PROBLEM
SOLUTION
If the armed indicator is flashing.
This indicates that there has been an
intrusion. Also, if a zone indicator is on,
this indicates which zone was violated.
To turn the zone indicator off, and stop
the armed indicator from flashing, press
the
LIGHT ON
or
LIGHT OFF
button
on the remote control. If a zone indicator
is not on, the violated zone will have
been one of the second eight zones.
Press
BYPASS
to see which zone was
tripped.
If the
POWERHORN
does not trip when
the alarm trips.
• Be sure you set the Housecode on
the
POWERHORN
to the same letter
and number as downloaded to the
Console.
• Plug the
POWERHORN
into another
outlet near the Console.
The Motion Sensor causes false alarms.
• All brands of Motion Sensors sense
motion by detecting a change in
temperature, therefore do not place
the sensor near any sources of heat
such as over an air conditioner or
heating vent.
• Do not place in a direct source of
bright light, such as sunlight.
• Do not place near cellular phones or
microwave ovens.
The MONITOR light is flashing.
This means that you need to call the
service station at 1-800-FOR-ORCA,
(1-800-367-6722) for setup of the
console.