- 4 -
SOLDERING IRON
Note: Before placing the soldering iron in the holder and turning it on,
remove the lid of the rosin flux that sits below the soldering iron tip
when it is in the holder.
1. Plug the Soldering Iron into the front power receptacle on the right
side of the unit and tighten the ring nut. Place the soldering iron in
the soldering iron holder provided.
2.
Turn on the soldering iron power switch - the LED display will light
up and show the last temperature that the soldering iron was used at
and begin to heat up to that temperature.
3.
To adjust the temperature of the soldering iron, press the blue “Up”
or “Down” arrows on the right side of the unit. The display will blink
indicating that the temperature is being set. When the temperature
has been set, the unit will stop blinking after about 3 seconds and the
soldering iron will start to heat to the newly set temperature.
4. To turn the soldering iron completely off - turn off the power switch.
ADJUSTING AIR FLOW
1. Take the hot air gun out of the holder - it will start heating and
blowing.
2.
Adjust the air flow with the Air Flow Control Knob from 20 up to 99.
Important:
When using a temperature higher than 300°C on the hot
air gun make sure the air flow is set at 45 or higher. This will prevent
damage to the hot air gun and increase the life of the heating
element.
