To Charge The Batteries:
1. Before riding the Scooter for the first time you must charge the Batteries. Thereafter, if
performance diminishes and/or the
Voltage Gauge drops below 30V,you must
recharge the Batteries.
2. Make sure the lgnition is in the “
OFF
” position.
(See Figure B.)
3. Plug the Charging Plug into the Scooter’s Power inlet Socket first, making sure to tighten
the ring of the Socket to hold the Charging Plug in place. Then, plug the 3-Prong Power
Cord Plug into the nearest 120 Volt, grounded, electrical outlet.
(See Figure C.)
4. Charge the Scooter for 5 hours. A red LED light will illuminate on the Gauge Panel of the
Scooter while it is being charged. Once the Scooter is fully charged, the red LED Light will
automatically turn to green. Note: when the Voltage Gauge on the Gauge Panel indicates
42V-43V that also means a full charge. If the Voltage Gauge indicates lower than 30V, you
must charge the Batteries.
(See Figures B and C.)
5.
IMPORTANT:
Do not charge the Scooter for more than 5 hours. Overcharging may limit
the life of the Scooter’s Batteries. Unplug after 5 hours to avoid overheating the Batteries.
Page 8
