1.
Attach Throttle and Brake Handle Grips
by Inserting the handle grips into the
handlebar posts.
2. Attach Left & Right Side Fairings as shown
in figure 4.
3. Mount trunk/cargo rack
4. Mount the seat post to the bottom of the
seat, then insert seat post into the receiver
and tighten the clamp
5. Install the rear taillight to the mounting
bracket being sure to attach the plug to
the scooter. (Fig. 6)
6. Install the enclosed 25amp glass fuse into
the fuse holder located on the right side of
your scooter.
Fuse Installation
Your scooter comes with a 25amp fuse that is
NOT installed at the factory.
1. Locate the 25amp glass fuse that came
with your scooter.
2. Locate the fuse holder on the right side of
the scooter
3. Remove the fuse holder cap and insert the
fuse into the cap first.
Then insert fuse/cap into fuse holder and gently
tighten. DO NOT OVER TIGHTEN THE CAP.
For more detailed assembly instructions go to:
http://www.x-tremescooters.com/electric_scoot
ers/x560/images/adobe/x-560-assembly-manu
al.pdf
Fig. 4
Fig.
5
Fig.6
Charging
Your scooter comes partially charged out of the carton. It is recommended
that you charge the unit for 6-8 hours prior to it’s first use. We also
recommend charging your scooter after each use and prior to storage.
WARNING:
Do not
allow your scooter to go into deep discharge, as this will
damage the batteries.
Page8