Cable
Spring Bolt
Seat Section
Support - Left
Cable
Seat Section
Support - Right
Bark Biters
Seat Section
Spring Bolt
Pin
Foot Section
Foot Section
Support - Left
Pin
Foot Section
Support - Right
Bark Biters
Spring
Bolt
Retaining
Pin
READ THIS MANUAL IN ITS ENTIRETY PRIOR TO USING THIS PRODUCT.
This instruction manual complies with the Treestand Manufacturers Association’s Standard Test Method for Treestand Fall Arrest Systems.
ASSEMBLY INSTRUCTIONS
- THE X-SCAPE -
FIGURE 1
FIGURE 1a
to adjust, remove Pin
from end of the Spring
Bolt. Pull Spring Bolt
back and adjust cable.
When at desired length
replace the Spring
Bolt, making sure it
locks into a hole in the
cable and replace the
retaining pin at the end
of the Spring Bolt.
STEP 1.
Attach the fixed end of (1) cable to the right support of the foot section
using (1) 5/16’’ x 1 1/4’’ hex bolt, (2) steel washers and (1) 5/16’’ nylock nut. Tighten
securely. Repeat for seat section. (Fig 1).
STEP 2.
Next, install (2) of the foot straps to the outside of the foot section support.
(Fig 2).
THIS PRODUCT COMES FULLY ASSEMBLED; HOWEVER, IT IS
ADVISABLE TO REFER TO THE DETAILED DIAGRAM BELOW
TO BECOME FAMILIAR WITH THE PROPER ASSEMBLY OF
YOUR TREESTAND.
Summary of Contents for X-scape XSCT344
Page 1: ......
