The indicator on the remote
controller does not light up
when I press the button.
The insulating film on the
battery has not been peeled
off.
Peel off the insulating film.
The battery is not properly
installed.
Take out the battery and install it
again. Make sure the contacts are
good.
The battery power is low.
Replace with a new battery.
Smoke alarms do not respond
to the remote controller.
Unsuccessful pairing.
Pair the remote controller and
smoke alarms again.
Out of range or interference
from the environment/other
devices.
Move to a closer location or
another place and try again.
Note:
The range of the remote control is dependent on many factors. Actual operational distance
will vary based on the actual operating environment or other environmental factors, and other
nearby electronic devices. Avoid signal blockage or interference. Electromagnetic waves
generated by appliances like TVs, induction cookers or microwave ovens maydisrupt normal
signal transmission and affect the operational wireless range.
FCC Statement
This equipment has been tested and found to comply with the limits for a Class B digital dev
ice, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable pr
otection against harmful interference in a residential installation. This equipment generates uses
and can radiate radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However, there is no gua
rantee that interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by turning the e
quipment off and on, the user is encouraged to try to correct the interference by one or more
of the following measures:
-- Reorient or relocate the receiving antenna.
-- Increase the separation between the equipment and receiver.
-- Connect the equipment into an outlet on a circuit different from that to which the receiver i
s connected.
-- Consult the dealer or an experienced radio/TV technician for help.
