33
33
Important Safety Instructions
Read all of these instructions before using your product. Also be sure to follow all warnings
and instructions marked on the product.
•
Do not block or cover the openings in the product’s cabinet.
•
Do not insert objects through the slots. Take care not to spill liquid on the product.
•
Use only the type of power source indicated on the product’s label.
•
Use only the power cord that comes with the product. Use of another cord may result in
fire or electric shock.
•
This product has its own power system, separate from and in addition to the printer’s
power system. There is a risk of electric shock unless all the power cables are unplugged
prior to maintenance.
•
Except as specifically explained in your documentation, do not attempt to service the
product yourself.
•
Unplug the product and refer servicing to qualified service personnel under the
following conditions: The power cord or plug is damaged; liquid has entered the
product; the product has been dropped or the cabinet damaged; the product does not
operate normally or exhibits a distinct change in performance.
•
The product is heavy and unwieldy. Have two people unpack or carry the product.
FCC Compliance Statement
For United States Users
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates,
uses, and can radiate radio frequency energy and, if not installed and used in accordance with
the instructions, may cause harmful interference to radio or television reception. However,
there is no guarantee that interference will not occur in a particular installation. If this
equipment does cause interference to radio and television reception, which can be determined
by turning the equipment off and on, the user is encouraged to try to correct the interference
by one or more of the following measures:
•
Reorient or relocate the receiving antenna.
•
Increase the separation between the equipment and receiver.
•
Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
•
Consult the dealer or an experienced radio/TV technician for help.
Notices
Summary of Contents for SpectroProofer
Page 1: ...Setup and Maintenance ...
Page 4: ... 4 4 Contents ...
Page 6: ...6 6 Introduction ...
Page 20: ...20 20 Setting Up the SpectroProofer ...
