Judge QC
2
P/N
JQCUSMA-ENG Rev. A
Consult this documentation in all cases where the Attention symbol
appears. This symbol is used to
inform you of any potential HAZARD or actions that may require your attention.
CE Declaration
Hereby, X-Rite PANTONE®® declares that this Judge QC is in compliance with the essential requirements and
other relevant provisions of Directive(s) EMC 2004/108/EC, LVD 2006/95/EC, and RoHS 2011/65/EU.
Federal Communications Commission Notice
NOTE: This equipment has been tested and found to comply with the limits for a Class A digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against
harmful interference when the equipment is operated in a commercial environment. This equipment
generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the
instruction manual, may cause harmful interference to radio communications. Operation of this equipment
in a residential area is likely to cause harmful interference in which case the user will be required to correct
the interference at his own expense.
Industry Canada Compliance Statement
This Class A digital apparatus complies with Canadian ICES-003.
Cet appareil numérique de la classe A est conforme à la norme NMB-003 du Canada.
Safety Information
•
IF THE EQUIPMENT IS USED IN A MANNER NOT SPECIFIED BY X-RITE PANTONE®, THE
PROTECTION PROVIDED BY THE EQUIPMENT MAY BE IMPAIRED.
•
PLEASE READ AND FOLLOW INSTRUCTIONS
: Read and follow all instructions before you attempt
to assemble, install or operate the unit.
•
CAUTION! THIS UNIT MUST BE EARTHED. DO NOT
connect to an ungrounded outlet.
DO NOT
use
with 2-wire extension cords or adaptors.
•
OBEY WARNINGS:
Please comply with all warnings and safeguards that we provide in this manual.
They have been written to keep you and your unit safe. If the unit is used in a manner not
specified in this manual, the protection provided by the unit may be impaired.
•
CANOPY WEIGHS APPROXIMATELY 15 KG. ASSEMBLED UNIT WEIGHS APPROXIMATELY 27 KG.
Take care when lifting and obey manual handling safety procedures.
•
TAKE CARE NOT TO TRAP FINGERS OR HANDS WHEN POSITIONING THE CANOPY ON TOP OF THE
BACK, SIDES AND BASE DURING ASSEMBLY.
Place hands under the front edge and on the outside
of the canopy only.
•
CHECK VOLTAGE SETTING PRIOR TO PLUGING IN THE UNIT.
Applying the incorrect voltage may
cause the fuses to blow. Contact your local X-Rite representative for replacement fuses and follow
the fuse replacement procedure in this manual.
•
ALWAYS UNPLUG THE UNIT BEFORE CHANGING THE VOLTAGE SELECTOR OR FUSE.
•
NEVER BLOCK ACCESS TO THE MAINS INLET AND POWER SWITCH.
The mains inlet and power
switch are located at the rear of the unit.
•
DO NOT BLOCK VENTS:
The vents allow air to circulate between the canopy interior and the
ambient air. Blocking the vents will cause hot air to build up within the canopy which may result in
inaccurate lighting conditions, damage to the equipment, and possible personal injury.
•
USE ONLY A PROPER POWER SOURCE:
Use the proper power source for this unit. Consult the
power label on the back of the unit for this information. Operation with a power source not
specified on the power label may result in inaccurate lighting conditions, damage to the
equipment, and possible personal injury.
Summary of Contents for PANTONE Judge QC
Page 1: ...EN Operation Manual...
