B A S F S P E C T R O P H O T O M E T E R 1 2 / 6
9
Powering On the Instrument
When powered-up, the instrument goes through a diagnostics test. The indicator LED and screen illuminate white, followed
by a splash screen before the main screen. This startup sequence will take a few seconds to complete.
Power on button
Press the power on/off and measure button or plug in the AC adapter to turn
on the instrument. If the instrument does not power up after pressing the
power button, the batteries may require charging.
You can press and hold the button for three seconds, and then tap Power
Off in the display to turn off the instrument
Connecting the AC Adapter
NOTE:
The instrument can operate from the AC adapter only. The battery pack does not need to be installed. The AC
adapter (X-Rite P/N SE30-277) overrides any charge condition of the battery pack in the instrument. Measurements can
be taken even with a very low battery condition when using the AC adapter and the battery pack is charging.
1.
Verify the voltage indicated on the AC adapter complies with the AC line voltage in your area.
2.
Open the access cover (1) at the back of the instrument.
3.
Insert the small plug from the AC adapter (2) into the input connector on the instrument.
4.
Plug the detachable line cord in the AC adapter and plug the line cord into the wall receptacle.
AC Adapter Ratings
Input: 100-240V 50-60 Hz
Output: 12VDC @ 2.5A
Operational hazard exists
if an AC adapter other
than X-Rite P/N SE30-277
is used.
(1)
(2)
Summary of Contents for BASF 12/6
Page 1: ...BASF Spectrophotometer 12 6 User Manual ...
Page 2: ......
