Wiring
Power and Outputs
X-D11
Power terminal ( +12V)
Remote terminal ( REM )
For RCA cable signal input:
Connect the radio power antenna lead = remote
turn on/off from the car stereo to the amplifier
remote connection. This turns on the amplifier
whenever the car stereo is turned on.
You can either use the built in remote cable in the
RCA cable itself or use a separate cable.
Sometimes a small disturbance may enter the
amplifier coming from the remote voltage , through
the built in remote wire and into the RCA cable.
Thus we recommend to use a separate remote wire
and run the RCA lead separate from remote wire,
power cables and speaker cables.
You can either use a crimp fork terminal or insert
the cable directly into the amplifier terminal. If there
is no remote voltage available from the stereo, you
must connect to the ignition key through the radio
or any accessories fuse.
4
Connect to a good chassis ground. The ground
connection should be clean, unpainted metal to prov-
ide a good electrical connection. Use a wire brush, a
scraper or a piece of an abrasive sheet to clean the
metal. Use a lock washer or two to secure contact.
Protect with silicon grease or by paint applied
afterwards.
+12V REM GND
Power Light / Protect light
The power light (green ) comes on when
the amplifier is turned on.
The protect light ( red ) comes on when
the amplifier shuts down from
overheating or short circuit.
Fuses
Use only 30 ampere
ATC blade type fuses.
X-D11 uses four 30
ampere fuses.
30A
For High Level input:
We recommend you to connect the remote wire
as described above. The amplifier will produce soft
on / soft off operation this way. You must set the
Hi level/Low level switch to Low level position in
this case.
In the case that there is no remote voltage available
from the car stereo or you want to simplify the
installation, the amplifier can be turned on/ turned
off by the high level input voltage. This is done
when the Hi level/Low level switch is set to Hi level
position. There is a small disadvantage that this
function gives soft turn off operation but some plop
sound when switching off.
Connect the battery cable to the +12 Volt terminal
on the amplifier.
A cable up to AWG 4 fits directly in the amp
12 V terminal, tighten with the hex screw.
Be sure to use a rubber grommet or a plastic
insulating tube where the cable passes the firewall
or other places when it can easily be jammed.
Use wire ties to secure to existing cables in the engine
room.
Protect
(Red)
Power
(Green)
Ground Terminal ( GND )
Connect the fuse holder as close to the vehicle
b as possible, using AWG4 = 21 mm
2
or
heavier cable. Use ring crimp terminal cable to
connect to b. Apply silicon grease to the
fuse to prevent corrosion. Use an ANL fuse holder
like the DLS FH2B with fuse value 100 A if you
use the AWG4 cable. If you load the amplifier
down to 1 ohm you should increase cable size to
AWG2 = 33 mm
2
, and use 150 A ANL fuse.
+12V REM GND
+12V REM GND
DLS
DLS FH2B
ANL fuse holder
Battery
+ pole
+12V REM GND
130.com.ua
Autogood products «130»
