X-IO Hyper ISE, User Manual

Page: 127 / 178

Xiotech—Proprietary 160337-000 Rev D, 30 September, 2013 Page 119
Monitoring ISE User Guide
Table 39: Power Supply Environment—CLI
Figure 85. Sample: Show Power Supply Display
Supercapacitor Detailed
The ISE-2, Hyper ISE, and ISE 7-Series contain two supercapacitor units (see Figure 1 on page 4) to maintain
cache memory in the event of a power outage.
To view detailed information about the supercapacitor units and their environment, enter the
show battery
command in the CLI. The following information is displayed for each supercapacitor unit (see Figure 86 for a
sample display from one supercapacitor unit).
Note.
Entering the
show battery
command in the CLI returns the same information as entering
show
supercap
.
The supercapacitor information fields are described in the following table (Table 40):
Table 40: Supercapacitor Environment Display
Figure 86. Sample: Show Battery Display
Field Comment
Status
Overall state of the SuperCap unit. This field usually reports
Operational
. Other possible
states include
Warning
,
Critical
, or
Non-Operational
.
Detailed Status
Any unusual state this SuperCap unit may be in. This field usually reports
None
.
Serial Number, Model, Part
Number
Component serial number, model, and part number
Hardware Version
—
Position
Physical bay location in the chassis, see Figure 101 on page 140
Temperature
Current temperature of supercapacitor unit
Power Supply-1
-------------------------------------------------------------------------
Status : Operational (None)
Blower (1) Status : Operational Position : 1
Speed Setting : 1 (2243 RPM) Serial Number : RG29395
Blower (2) Status : Operational Part Number : SP632-2P
Speed Setting : 1 (2236 RPM)
Temperature : 31 C (Warning: 50 C, Critical: 60 C)
-------------------------------------------------------------------------