Your X-HMT
™
should be 75% charged when you first go to use it. For best battery life results,
please run your X-HMT
™
unit until it is depleted (unit will blink red and no longer run) before
charging it back to full for the first time.
Hold the X-HMT
™
with
the button panel on
the right side facing
you.
Place the X-HMT
™
into
the Dynamic Variable
Lumbar (DVL) support
of your chair.
Hold the X-HMT
™
back cover with the
embedded logo on the
left, facing you.
Place the cover behind the back
support bar.
Align the left edge of the cover with the
left edge of the DVL. Adjust the back
cover so all clips are tucked within the
DVL frame and the X-HMT
™
is covered
except for the button panel
Installation
Gently push in the
right side of the
X-HMT
™
front cover
and then pull towards
you to release the clips
from the chair.
Once all of the clips
have been released,
remove the cover out
from the right side.
Make sure to unplug
the X-HMT
™
unit before
removing it from your
chair.
Hold the X-HMT
™
unit
and pull it out towards
you and to the right.
Uninstall
Constant
Massage
1
st
Variable
Massage
2
nd
Turn off
X-HMT
™
3
rd
Massage Settings
Using Your X-HMT
™
There are two levels of massage intensity for your X-HMT
™
. Press the power button once for
Gentle Massage. You will see two green lights to denote gentle massage. Press the intensity
button one time for more Powerful Massage. You will see a blue light next to the intensity
button to denote a powerful message (the power button light will still be green).
There are two different massage modes for your X-HMT
™
– Constant and Variable. The
Constant Mode is activated when you first press the power button. To activate the Variable
Massage Mode press the power button a 2
nd
time. The light next to the power button will
turn blue to indicate the variable mode is activated. Press the power button a 3
rd
time to
turn off massage. Note: the power button only controls massage, not heat.
There is one heat setting for your X-HMT
™
. Press the Heat button once to turn the heat on. A
red light will come on. Press it again to turn the heat off.
1
1
2
3
4
2
3
1
2
3
4
1
4
5
2
3
To fully charge your X-HMT
™
fully you must plug it in for four or five hours.
Using Massage
function only
or
5
Twenty
15-minute
cycles
5 Hours
Using Heat and
Massage function
together
or
1
Seven
15-minute
cycles
1 Hour
45-minutes
: 45
Using Heat
function only
or
1
Seven
15-minute
cycles
1 Hour
45-minutes
: 45
Gentle Massage
(Green Light)
Powerful Massage
(Blue Light)
Intensity Button
(Powerful Massage)
Heat Button
55 °C / 131 °F
Power Button
(Gentle Massage)
Your X-HMT
™
can be used while plugged in, or on battery power only. If you are only using
battery power you can expect the following number of 15-minute cycles before you have to
charge it again:
Your X-HMT ™ will always run for a 15-minute cycle and then shut off automatically for
safety.
