BIND
:
First blink after power on indicate the receive mode,
■
S-FHSS
,
■
D16 non-EU
,
■
D16 EU-LBT
.
S-FHSS BIND
D16
non-EU and EU-LBT BIND
Turn on the TX, then power on AC2000 while pressing the
key,
GREEN
LED fast blink meaning bind mode, user can
release the key. Bind procedure is completed and the
receiver working normally when
GREEN
LED solid.
Power off the TX, Power on AC2000 while pressing the key,
GREEN
LED fast blink meaning bind mode. Set TX into D16
bind mode,
RED
LED solid meaning bind success. TX exit
bind mode,
GREEN
LED solid meaning working normally.
RECEIVE MODE SWITCH
:
When AC2000
RED
or
GREEN
LED solid, Press the key and hold LED will go off, after 3 seconds
YELLOW
LED will turn on, release the key AC2000 will switch to another receive mode and restart automatic.
FAILSAFE:
Please set failsafe in your radio, depend on the radio S-FHSS, D16 non-EU and D16 EU-LBT shoWuld have at
least 2 failsafe settings as follow (different radio may name the setting differently):
1.
HOLD
,
S.BUS sent the value when received last time, we suggest switch channel use this setting.
2.
CUSTOM
,
this setting can custom S.BUS sent value when no signal.
In most cases, user can set AIL, ELE, YAW middle (
CUSTOM
1500), THR low (
CUSTOM
less than 950), other switch channels
use
HOLD.
In most cases please make sure
[ARM] / [DISARM]
channel failsafe setting
HOLD
in
[ARM]
value. Because if
failsafe setting use
[DISARM]
value
when briefly lost signal, the drone will switch in
[DISARM]
state, once the signal from radio
received the drone maybe can’t switch to
[ARM]
state because THR high (more than 1000), this will result crash when briefly
lost signal. So
[ARM] / [DISARM]
channel failsafe setting should
HOLD
in
[ARM]
value or use
CUSTOM
in
[ARM]
value, if
signal lost a long time because THR low (less than 950), drone will just crash, not fly away.
Before first flight, we suggest remove propeller then [ARM] the drone, push THR middle make motor rotating, power
off the radio to simulate lost signal, motor should STOP or IDLE rotating, correct failsafe setting is when power on the
radio drone should can control immediately not need do [ARM] / [DISARM].
AC2000 have 2 LEDs correspond to the 2 wireless systems, we call them
W1
and
W2
for short. By default, receiver read
W1
first, so when signal good
W1
’s
LED should
BLUE
(preferred signal),
W2
’s LED should
GREEN
(backup signal),
Receiver will use
W2
when
W1
lost signal,
W2
’s LED will
BLUE
at this time.
Two antennas should be placed
at 90 degrees to each other.
Suggest distance test befor use, when close to
THE FURTHEST DISTANCE
：
<a> . Hold
W1
antenna,
W2
’s
BLUE
LED should turn on.
<b> . Release
W1
antenna
,
hold
W2
antenna,
W1
’s
BLUE
LED should on.
If hold antenna can not cause
BLUE
LED switch when colse to
THE FURTHEST
DISTANCE
，
maybe another antenna place unreasonable cause signal bad.
(
NOTICE: when signal good, hold antenna will not cause
BLUE
LED switch
)
