LASER DIFFUSER
9
Control Installation
• Locate an appropriate place to put the control unit inside the bonnet. It is
recommended to locate near battery like the top of the battery. Using the 3M
fastener tapes at the bottom or cable ties at the handle to fix.
• Connect the sensors to the FR1, FR2, FR3 sockets for the front side. Connect the
sensors to the REAR1 and REAR2 sockets for the rear side. Additionally, one more
sensor can connect at ‘OPTION’ socket for front or rear side to cover large vehicle.
• Connect the DC12V power cable socket from the hardwire kit. There are two ‘Y’
type terminals from the other side of hardwire kit for battery connection. Connect
the red line ‘Y’ terminal at the ‘+’ and connect the black line ‘Y’ terminal at the ‘-’
location. When the power is correctly connected, the red light is on at the ‘PWR’ of
the board.
• There is black antenna line inside the control unit. Pull out the antenna line outside
through the housing hole. It is recommended to stretch an antenna not to hide for
better wireless connection.
☞
There is cooling gray pad attached between the board and top housing. It cools
down the temperature inside the housing.
FRONT
FR 2
FR 3
BATTERY
12V POWER CONNECT RECEIVER
FR 1(CENTER)
REAR
