Setup and Configuration
The SW-740-TX is configured using RS-232 or IP commands for Output Resolution, and EDID. Follow these steps to properly configure the transmitter based
on the system requirement.
Note:
The steps and information provided in this QSG are for basic operation of the transmitter out of the box. Refer to the SW-740-TX API for full configuration
settings.
1. Assign a Static IP Address to ensure proper communication on an IP Network.
2. Set EDIDs to be used at each input of the device. See
Communication Settings
The SW-740-TX contains a web UI that can be accessed by connecting to a
network and entering the IP address. We recommend that the IP address is
changed from default before accessing the web UI for the first time.
RS-232 and IP Settings
Baud rate:
115200
Data Bits:
8bits
Parity:
None
Stop Bits:
1bit
Flow Control:
None
Default IP Address
192.168.11.43
Default IP Port
23
Configuring Input EDIDs
By default, all inputs are set to an EDID or 1920x1080@60Hz 2CH. However, this can be configured to suit the installation.
Troubleshooting
No or Poor Quality Picture (snow or noisy image)
• Verify that power is being supplied to the transmitter and receiving device.
• Verify that all HDMI and HDBaseT connections are not loose and are
• functioning properly.
• Verify that the HDBaseT cable is properly terminated following EIA568B
• standard.
• Verify that the output resolution of the source and display is supported by
• this transmitter.
• Configure EDID Settings to a lower resolution.
• If transmitting 3D or 4K, verify that the HDMI cables used are 3D or 4K rated.
No or Intermittent 3rd party Device Control
• Verify that the IR, RS-232, and Ethernet cables are properly terminated
Relays Not Functioning
• Verify polarity of the relay connections.
Troubleshotting Tips
• WyreStorm recommends using a cable tester or connecting the cable to
other devices to verify functionality.
Copyright © 2020 WyreStorm Technologies | wyrestorm.com
SW-740-TX Quickstart Guide | 200729
UK: +44 (0) 1793 230 343 | ROW: 844.280.WYRE (9973)
3 of 4
Set Input EDID
SET EDID [Input] [Resolution] [Device]<CR><LF>
Example: SET EDID in1 1 <CR><LF>
Response: EDID SET in1 1 <CR><LF>
Query Input EDID
GET EDID [Input] <CR><LF>
Example: GET EDID in1 <CR><LF>
Response: EDID GET in1 1 <CR><LF>
Input= VGA | DP | TXHDMI | USBC | RXHDMI1 | RXHDMI2
Resolution={Below tables based on connection}
VGA EDID
HDMI/USB-C EDIDs
8: 1024x768@60Hz 2CH
8: 1600x900@60Hz 2CH
7: 1280x768@60Hz 2CH
7: 1600x1200@60Hz 2CH
6: 1360x768@60Hz 2CH
6: 1680x1050@60Hz 2CH
5: 1440x900@60Hz 2CH
5: 1920x1200@60Hz 2CH
4: 1600x900@60Hz 2CH
4: 1280x720@60Hz 2CH
3: 1680x1050@60Hz 2CH
3: 1920x1080@60Hz 2CH
2: 1920x1080@60Hz 2CH
2: 3840x2160@30Hz 2CH
1: 1920x1200@60Hz 2CH
1: 3840x2160@60Hz 2CH
