Copyright © 2019 WyreStorm Technologies | wyrestorm.com
RXV-70-H2 v2 Quickstart Guide | 190319
UK: +44 (0) 1793 230 343 | ROW: 844.280.WYRE (9973)
3 of 4
Setup and Configuration
ARC and Audio In Settings
The audio returned to the matrix can be configured to be either from the
displays HDMI ARC channel or the S/PDIF In on the receiver. Set the switch on
the front of the receiver accordingly.
Set the switch to
ARC
to send the audio returned
from the display connected to the receivers HDMI
Out via Audio Return Channel back to the matrix.
Set the switch to the
S/PDIF In
to send audio from
the receivers S/PDIF In back to the matrix.
EDID Configuration
This receiver uses EDID pass-through from the display to the source. No configuration is required for EDID settings.
Troubleshooting
No or Poor Quality Picture (snow or noisy image)
• Verify that power is being supplied to the transmitter and receiver.
• Verify that the HDBaseT cable is properly terminated following EIA568B
standard.
• Verify that the output resolution of the source and display is supported by
this extender.
• If transmitting 3D or 4K, verify that the HDMI cables used are 3D or 4K rated.
• Verify that all source and HDBaseT connections are not loose and are
functioning properly
No or Intermittent 3rd party Device Control
• Verify that the RS-232/Ethernet cables are properly terminated.
• Verify that emitters/receivers are compatible with WyreStorm IR.
• If using an IR control system, verify that it is connected using the CAB-IR-
LINK cable.
