![Wyrestorm MX-0606-HDBT-H2 v2 Quick Start Manual Download Page 2](http://html1.mh-extra.com/html/wyrestorm/mx-0606-hdbt-h2-v2/mx-0606-hdbt-h2-v2_quick-start-manual_1001922002.webp)
Front Panel
Rear Panel
HDMI In/Out
19-pin type A HDMI female:
Supports HDMI and DVI/D (requires adapter-not included). See
HDMI/HDBaseT Wiring
for important wiring guidelines.
HDBT Out
8-pin RJ-45 female
Connect to the
HDBT In
of an HDBaseT receiver. See
HDMI/HDBaseT Wiring
for important wiring guidelines.
HDBT Out LED Operation
Green Solid:
HDBaseT link has been established with the receiver.
Green Flashing or Off:
HDBaseT link has NOT been established with the receiver.
Amber Flashing:
HDBaseT functioning normally and can establish a link with the receiver.
Amber Off:
HDBaseT has discovered a fault and cannot establish a link with the receiver.
IR RX/Ext/TX
IR RX/Ext - 3.5mm (1/8in) Stereo Jack:
Connect to an IR receiver for matrix control (Ext) or IR pass-through (RX) via HDBaseT.
IR TX - 3.5mm (1/8in) Mono Jack:
Connect to an IR emitter to control a local device from the remote display location via HDBaseT. See
IR Wiring
.
ARC Out
RCA Female (Digital Coax)
Supports HDMI and DVI/D (requires adapter-not included).
Update/RS-232
Mode
Normal:
RS-232 Matrix control.
Update:
RS-232 firmware update.
Dials:
Selects card position to update.
Ethernet/LAN
8-pin RJ-45 female | 10/100 Mbps auto-negotiating
Zones 1-8:
Connect to a network router or switch for sending Ethernet to the remote zone via HDBaseT.
LAN:
Connect to a network router or switch for accessing the Web UI or matrix control via IP.
EDID
4 Position Dipswitch:
Used to set EDIDs to correct resolution conflicts between the source and the display. See
EDID Settings
.
RS-232
9-pin DB9 Female:
Used to control the matrix functions and firmware updates. See
RS-232 Wiring
.
Power
Power Switch: 0 –Power Off / I – Power On
Fuse Holder
IEC Power Cord Port
Output Channel
Indicator
1-6 (6x6) or 1-8 (8x8)
Displays the source input number currently selected for the corresponding output number.
IR Sensor
Receives IR signals from included handheld IR remote or attached emitter from IR control system for switcher control.
Source/Output
Navigation
Left/Right:
Output Selection
Up/Down:
Input Selection
Enter:
Confirm Selection
A
B
C
Copyright © 2016 WyreStorm Technologies |
wyrestorm.com
MX-0606-HDBT-H2 v2 | MX-0808-HDBT-H2 v2 Quickstart Guide | 160913
North America: 518-289-1294 | EMEA/ROW: 44 (0) 1793 230 343
2 of 4