Front Panel (TX/RX)
Rear Panel (TX/RX)
Power LED
Solid:
The receiver is powered On
Off:
The receiver is powered Off
Status LED
Flashing:
The receiver is operating normally.
Off:
The receiver is Not operating normally.
HDCP LED
Solid:
HDCP content is present.
Flashing:
HDCP content is not present.
Off:
No signal.
LINK LED
Solid:
Link to receiver has been established.
Flashing:
Link to receiver has not been
established.
RS-232 Mode
Switches the mode for the RS-232 port.
Normal:
RS-232 HDBaseT pass-through.
Update:
RS-232 firmware update.
Power Input
5.5mm Screw Down Barrel Jack
2-pin Phoenix Connecter
Connect to the included 18V DC 1A power
supply to the transmitter. A power supply
is not required on the receiver as it will be
powered using PoH. See
Power Supply Wiring
for important information.
Status LED
8-pin RJ-45 female | 10/100 Mbps auto-
negotiating
Connect the transmitter
HDBT Out
to receiver
HDBT In
using the cable created in
Pre Wire
step 1.
HDCP LED
IR TX
- 3.5mm (1/8in) Mono Jack: Connect
to the supplied IR emitter to control a local
device from the remote display location via
HDBaseT.
IR RX
- 3.5mm (1/8in) Stereo Jack: Connect
to the supplied IR receiver to send IR to the
remote display location via HDBaseT.
See
IR Wiring
for more information.
LINK LED
19-pin type A HDMI female
Supports HDMI and DVI/D with adapter
RS-232 Mode
3-pin Phoenix Connector
Used to transmit RS-232 over HDBaseT to
the remote location and for firmware updates.
See
RS-232 Wiring
for more information.
Copyright © 2016 WyreStorm Technologies |
wyrestorm.com
EX-70-H2 Quickstart Guide | 160803
North America: 518-289-1294 | EMEA/ROW: 44 (0) 1793 230 343
2 of 4
EX-70-H2 Transmitter
EX-70-H2 Receiver
A B C D
E
EX-70-H2 Transmitter
EX-70-H2 Receiver
A
B
C
D
E
