Wynn's EW30001, Operation Manual

Page: 14 / 19

13
Remove Cooling System
Pressure Cap.
NOTE: Use extreme caution
when removing Pressure Cap
from a hot cooling system that
is under pressure.
Insert cone adapter into radiator
/ remote reservoir, making sure
the tip of the cone is
submerged.
TIP: If servicing from degas
bottle, slide the hose through
the cone long enough to reach
near the bottom of the bottle.
When no more fluid is being
removed break the seal and
reseal. Repeat process until all
old coolant is evacuated. When
all coolant has been evacuated
allow the radiator hoses to
collapse by vacuum.
Once radiator hoses are
completely collapsed and no
more fluid is being removed set
the switch the OFF position
Turn the Vacuum / Fill Control
dial to the desired fluid type to
fill the radiator.
IMPORTANT: Be sure not to
break the vacuum seal between
the rubber cone and the
radiator/cooling system once
the final evacuation step has
been completed.
When new fluid stops entering
the radiator, remove the cone
adapter from the radiator.
Top off radiator if needed and
refill overflow bottle (refer to
top-off procedure).
Replace Cooling System
Pressure Cap.