5. do not overreach. Keep proper footing and
balance at all times.
Proper footing and balance
enable better control of the tool in unexpected
situations.
6. use safety equipment. Always wear eye
protection.
Dust mask, non-skid safety shoes,
hard hat or hearing protection must be used for
appropriate conditions.
Power tool use and care
1. do not force the power tool. use the correct
power tool for your application.
The correct
tool will do the job better and safer at the rate for
which it is designed.
2. do not use the power tool if switch does
not turn it on or off.
Any tool that cannot be
controlled with the switch is dangerous and must
be repaired.
3. disconnect the plug from the power source
before making any adjustments, changing
accessories or storing the tool.
Such preventive
safety measures reduce the risk of starting the
tool accidentally.
4. Store idle power tools out of reach of children
and do not allow persons unfamiliar with the
power tool or these instructions to operate
the power tool.
Power tools are dangerous in
the hands of untrained users.
5. maintain power tools. check for misalignment
or binding of moving parts, breakage of parts,
and any other condition that may affect the
power tools operation. If damaged, have
tool serviced before using.
Many accidents are
caused by poorly maintained tools.
6. Keep cutting tools sharp and clean.
Properly
maintained tools, with sharp cutting edges, are
less likely to bind and are easier to control.
7. use the power tool, accessories and tool bits,
etc. in accordance with these instructions,
taking into account the working conditions
and the work to be performed.
Use of the
power tool for operations different from those
intended could result in a hazardous situation.
Service
1. Have your power tool serviced by a
qualified repair person using only identical
replacement parts.
This will ensure that the
safety of the power tool is maintained.
Safety Symbol explanations
Volts
Amperes
Hertz
Alternating Current
Class II Tool
IP Symbol
Ground Terminal (Protective Earthing)
ON
OFF
Refer to Instruction Manual
Variability in Steps
V
A
Hz
IPX4
FIGURE 1.0 - SAFETy SyMBOLS
eN
g
lI
SH
Page 4
Form No. W160 02/10
