Assembly, Mounting and Installation Instructions
Step 1. Keyboard Preparation (Optional)
It is recommended, but is not required, to disassemble the
slides from the tray for easier installation. This is easily
done by first depressing the plastic lever as shown in
Figure 1 and then pulling the slide members apart.
Repeat for other slide.
Step 2. Determine Mounting Direction
Measure mounting location to determine if the mounting
brackets should face inwards or outwards. If width is less
than 24" the brackets must face inward. If the mounting
location is 24" or greater, the brackets may face either
direction.
Step 3. Determine Drop Height
A. Measure the maximum height of the keyboard that you
will be using. Compare keyboard height with the adjust-
ment heights in Chart A to determine at which height
position the mounting brackets need to be installed.
Chart A
Max. Keyboard Height (inches)
Position 1
3.60
Position 2
3.38
Position 3
3.15
Position 4
2.93
Position 5
2.70
Position 6
2.48
Position 7
2.25
B. Alternatively, you may use Chart B and Figure 2 to
determine what height is desired to allow a knee clear-
ance or chair clearance, underneath the keyboard after
installation.
Chart B
Height Loss Under Surface (inches)
Position 1
3.78
Position 2
3.56
Position 3
3.33
Position 4
3.11
Position 5
2.88
Position 6
2.66
Position 7
2.43
Step 4. Assemble Brackets
Attach mounting brackets to the slide cabinet member, in
the direction (step 1) and position (step 2 a or b), using
the #8 x
1
⁄
4
" self tapping screws provided in the hardware
kit.
Position 1
Position 7
Position 1
Position 7
19 inches
height from floor
to underneath surface
desired
clearance
height
loss
floor
desk top
table leg
Figure 2
Figure 3
Figure 1