Würth 5708 300 1, Translation Of The Original Operating Instructions, Page: 20 / 27

20
Tool Specifications
Intended Use
The diamond impact drill can be used for drilling with
dry diamond core bits. With mounted drill chuck, the
machine is suitable for impact drilling in masonry and
for drilling in wood and steel. The power tool is not suit-
able for wet drilling in concrete.
For damage caused by usage other than intended, the
user is responsible.
Operation
Mains supply
In damp locations and outdoors, operate the power
tool with a residual current device (FI, RCD, PRCD) with
a rated residual current of 30 mA or less.
Connect the power tool only to single-phase alternat-
ing current and only to mains voltage as indicated on
the rating plate.
Connecting to socket outlets without earthing contact is
also possible.
Connect the power tool to the socket outlet only when
the machine is switched off.
Restarting protection
The restarting protection prevents the power tool from
restarting after a power failure. Before resuming work,
you must switch the power tool off and then on again.
Overload protection
When the motor is subject to overload, the overload
protection is actuated. The power tool then continues to
run slowly to cool the motor windings. Only after suffi-
cient cooling can the power tool be switched on
again.For this, switch the power tool off and then on
again.
Soft impact
Depending on the material to be worked, the soft
impact feature can significantly reduce the drilling time
or prolong the tool life of the diamond segments.
Working Advice
To achieve a greater drilling process, remove the pilot
bit after a drilling depth of approx. 10–15 mm. Insert
the core bit into the existing groove and run the power
tool slowly.
Drill holes that do not have to be accurately set can be
carried out without a pilot drill. Apply the core bit
lightly inclined. From a drilling depth of approx. 5 mm,
slowly straighten the power tool. (Only possible with
short core bits).
If drilling core come loose, pull the core bit out of the
material and remove the core.
A sharpened core bit facilitates the operation and the
drilling progress. Options for sharpening: Drilling in
lime-sand brick or in a drilling plate.
Symbols
Diamond impact drill EDSB 160-E
Article number 5708 300 1
Rated power input 1500 W
Output power 820 W
No-load speed
1. gear
0–1500 rpm
2. gear 0–3000 rpm
Speed, full load
1. gear, max.
890 rpm
2. gear, max. 1770 rpm
No-load impact rate, max. 48000 rpm
Drilling diameter, max.
1. gear
80–162 mm
2. gear 32–90 mm
Drilling spindle 5/8" 16 UNF
Collar diameter 57 mm
Weight according to EPTA-Pro-
cedure 01 4.4 kg
Protection class II/
dark marked area:
Handle (Insulated gripping sur-
face)
Warning
Before any work on the machine
itself, pull the mains plug.
CE mark
OBJ_BUCH-0000000384-001.book Page 20 Wednesday, April 10, 2019 3:20 PM