4
Buy Online! Wurtec.com
Installation & Service Manual
Timeout Jumper Instructions
onds and then release. At this point you
will see a display of eight zeros with the
first zero blinking. The number blinking
is the number waiting to be changed.
To change the number use the “UP” or
“DN” button until you have come to the
desired number, then press and hold
the “Prog” button for approximately two
seconds and then release; you will then see the next character blink; repeat as
desired fro all numbers. When finished press and hold the “Start” button for ap-
proximately two seconds and release.
Program Status – Program status is a non-programmable menu. This option
scrolls all the information that has been programmed into the Wurtec Time out
Jumper. To view scroll to the “Pro-
gram Status” menu, press and hold
the “Prog” button for approximately two
seconds and then release. To stop
the status scrolling, press and hold the
“Start” button for approximately two
seconds and then release. You will
then see “Program Status” scroll across
tje screen again. At this point you can
use the “UP” or “DN” button to scroll through the menus or press and hold the
“Start” button for approximately two seconds to put the Jumper into “sleep”
mode.
Changing Batteries - To change the batteries in the Timeout Jumper you
first need to remove the four screws in the four corners of the enclosure. The
jumper will separate into three pieces.
The top of the enclosure, the bottom
of the enclosure and the guide plate
for the lead wires; the jumper board
is screwed internally to the top of the
enclosure. On the back side of the
jumper there will be two AAA batter-
ies in black plastic holder on the back
side of the board. Remove the dead
batteries from the holder and replace them with two fresh AAA batteries. To
reassemble the enclosure place the guide plate into the channel of the bottom
half of the enclosure, then place the top half over that. Replace the screws in
the four corners of the enclosure.
