wtw IQ SENSOR NET System 2020 XT, Operating Manual

Page: 42 / 216

Installation System 2020 XT C
ONNECT
3 - 14
ba75970e01 10/2012
3.5.2 Stacked mounting of MIQ modules:
Note
For optimum stability, a maximum of three MIQ modules can be mount
-
ed in any one stack. Only one MIQ power supply module may be
mounted per module stack.
Mounting direction MIQ modules can be stacked on top of one another from both sides. All
the required installation materials are contained in the scope of delivery
of the MIQ modules.
Which variant is suitable for a specific case depends on whether and
how an MIQ module is already permanently installed at a location (e.g.
on a wall or in a panel), among other factors.
Materials required

2 x ISO blind nuts M4

2 x cheese-head screws M4x16 with plastic washer

1 x contact base with two plastic tapping screws.
Tools

Phillips screw driver.
Variant 1 - stack expansion for
-
wards.
The back of an MIQ module is
attached to the lid of another
MIQ module
(page 3-15).
Variant 2: - stack expansion
backwards.
The lid of an MIQ module is
attached to the back of another
MIQ module (page 3-18).
In the case of panel mounting, the front MIQ module can
only be installed individually in the switch cabinet aperture.
Only then can further MIQ modules be added to its back
(variant 2). If necessary, dismantle the front MIQ module
from an already mounted stack before mounting.