wtw DIQ/S 182-XT-4, Operating Manual

Page: 94 / 152

Outputs System 182-XT-4
6 - 2 ba75753e06 12/2014
Functions for current
outputs

Recorder

PID controller

Fixed current value
Valve outputs
(MIQ/CHV PLUS)
The MIQ/CHV PLUS valve module is administrated by the system as a
valve output (designation, MIQ/CHV PLUS V1). The relevant setting
tables are available via the SETTINGS menu.
6.2 Linking and adjusting: general procedures
6.2.1 linking outputs
Linking options The following options of linking outputs are available:

Sensor Sxx
The output is linked with sensor 0x

Sensor S01&S02
The output is linked to both sensors S01 and S02.
This option is available for relay outputs only.

System
Select this option if you want to use the output for system monitoring
(details, see section 6.4.2).
Procedure:
linking outputs
Proceed as follows if the output was not yet linked. If you want to
change a link, you have to erase the existing link first.
You can view the current states of the relay and current
outputs in the measured value and status display (see
section 4.2).
The installation and settings of the valve module are
described in the operating manual of the MIQ/CHV PLUS.
1 Open the SETTINGS menu with
s
.
2 Select the menu item Relay output Rx or mA output Cy with
w
and
g
and confirm. A list with all linking options is
displayed.