INSTALLATION
RECOMMENDED TOOLS FOR PROPER INSTALLATION
1)
Tie wraps to secure cable runs.
2)
Set of open end wrenches including 7/16” for mounting bolts.
3)
Cordless power drill for mounting some brackets.
4)
Safety cable recommended (prevents camera falling during overhead
installations).
5)
Self-sealing connector tape to weatherproof all cable connections.
INSTALLATION PLANNING
1)
The maximum cable length that should be planned for is about 750 feet, which is
based primarily on the limitations of transmitting the video signal over long
coaxial cable distances.
2)
The Sidewinder SW720A camera draws up to 50 Watts maximum, which
translates to about 0.59 Amps at the low line voltage limit of 85VAC.
3)
Be sure to verify that there are no physical obstructions that might prevent the
camera from turning freely in all directions. The camera must be able to rotate
360 degrees in each axis during power up initialization in order to properly
initialize the pan and tilt drive positions.
4)
Be sure to verify that there are no physical obstructions in the way of any required
viewing directions.
5)
Be sure that there is access to the end of the umbilical cable on the bottom of the
camera to facilitate connecting and disconnecting the camera while it is in place
on the mounting bracket or pole.
UNPACKING
Please examine the equipment carefully when unpacking the shipping container. If any
damage is noted please be sure to file a claim with the carrier. WTI is not responsible for
any damage that occurs during shipping. Please verify that all of the contents are present
and carefully check the packing material for any loose items before recycling it.
EQUIPMENT SUPPLIED WITH UNIT
1.) Camera
2.) 4 each ¼-20 x ¾” mounting screws with washers
3.) Quick Start Manual
EQUIPMENT THAT MAY BE REQUIRED, BUT NOT SUPPLIED WITH UNIT
1.)
Mating connector and strain relief for umbilical extension cable
2.)
Camera mounting bracket
3.)
Interconnect cables
4.)
Video monitor
5.)
PC or laptop computer
6.)
Setup software
SW720A
WTI ~ Page 10 of 27
Summary of Contents for Sidewinder SW720A
