2-2
Unit Description
2.2. VMR Standard Series - Back Panel
As shown in Figure 2.2, the VMR Series Back Panel includes the following components:
1.
Power Circuit A - Power Inlet:
An IEC320-C20 AC inlet which supplies power to
VMR control functions and Circuit “A” outlets. Also includes cable keeper
(not shown.)
Notes:
• VMR-4HS15 and VMR-8HS20 series units feature a single Power Inlet.
• VMR-HD4D-30 and VMR-HD4D-32 units feature attached power supply
cables.
2.
Power Circuit B - Power Inlet:
An IEC320-C20 AC inlet which supplies power to
VMR control functions and Circuit “B” outlets. Also includes cable keeper
(not shown.) (Not present on VMR-4HS15 and VMR-8HS20 series units.)
3.
Power Circuit A - Switched Outlets:
AC Outlets that can be switched On, Off,
rebooted or set to default state in response to user commands.
4.
Power Circuit B - Switched Outlets:
Same as Item 3 above. (Not present on
VMR-4HS15 and VMR-8HS20 series units.)
5.
Alarm Indicator Lights:
Two LEDs which light when an alarm condition is detected
at the corresponding power circuit. Note that VMR-4HS15 and VMR-8HS20 series
units only include one power circuit and one Alarm Indicator Light. For information
on Alarm Configuration, please refer to Section 8.
6.
Network Port:
An RJ45 Ethernet port for connection to your 100Base-T, TCP/IP
network. Note that the VMR features a default IP address (192.168.168.168). This
allows you to connect to the unit without first assigning an IP address. Note that the
Network Port also includes two, small LED indicators for Link and Data Activity. For
more information on Network Port configuration, please refer to Section 6.8.
A1
A
B
A 2
A3
A4
A5
A6
A7
A8
B1
B2
B3
B4
B5
B6
B7
B8
10/100 BaseT
ACT
A
B
ALARM
LINK
1
3
2
4
5
6
Figure 2.2: VMR Standard Series - Back Panel (Model VMR-16HD20-1 Shown)
