NOTE: The above memory configuration can also be configured by using SIM3
and SIM4 , as the memory configuration is an auto detect design.
Mainboard Connectors
====================
J6 Speaker connector will be connected to the speaker ofyour computer
case.
J2 Reset Switch connector will be connected in your computer case front
panel. Resetting the system , it will restart the computer from
self-test without turning off the power supply. This connection is
always at "off" position.
J5 Keylock and Power LED connector will be connected in your computer
case front panel. Keylock is used to lock the keyboard. Power LED will
light up when you turn on your power supply.
J3 Turbo Switch Connector will be connected in your computer Case front
pannel.
J4 Turbo LED Connector will be connected in your computer Case front
pannel.
JP21
External SMI switch will be connected in your computer case front panel.
This is used to activate the SMI function without waiting the setup
time of the power managerment setup.
Note: some case does not include this switch.
J1
External battery connector is used for the external battery. This is
used when internal battery is not connected.
KB1 Keyboard connector,this is used for inputting signal from the keyboard.
P1/P2 Power Supply connector is connected from the output of the powe supply.
Most of the power supply has two connectors which will be connected
tothe mainboard. Each connector has six wires ,two of the wires are
black. To connect to the mainboard, make sure that the black wire is in
the middle. Wrong connection will cause damage to the mainboard.
CMOS Charge / Discharge (Black jumper Cap)
==========================================
CMOS Charge / Discharge is used to discharge and charge CMOS. If you
discharge the CMOS all the data will be erased.
J1
2-3 Charge CMOS
1-2 Reset(discharge) CMOS
1-4
External Battery Connector
Flash ROM Voltage Selector Red jumper Cap
=========================================
JP8 EPROM
1-2 Flash ROM 5 Volts (SST Brand)
2-3 Flash ROM 12 Volts (Intel, MX Brand)
Note: Wrong voltage setup will damage BIOS. Please call Edom for detail.
AWARD BIOS SETUP
================
Award BIOS support plug and play function and has a built-in setup program
that allows the users to modify the basic system configuration. This type of
information is stored in CMOS so that it retains the setup information when
the power is turned off.
1. Turn on or reboot the system. when the below message appears at the
