wsm Kubota L4100, Workshop Manual

Page: 42 / 346

GENERAL L4100, WSM
G-27
(EU)
Checking Radiator Hose and Hose Clamp
Check to see if radiator hoses are properly fixed every 200
hours of operation or six months, whichever comes first.
1. If hose clamps (2) are loose or water leaks, tighten hose clamps
(2) securely.
2. Replace hoses (1) and tighten hose clamps (2) securely, if
radiator hoses (1) are swollen, hardened or cracked.
Replace hoses and hose clamps every 2 years or earlier if
checked and found that hoses are swollen, hardened or
cracked.
Q
Precaution at Overheating
Take the following actions in the event the coolant temperature
be nearly or more than the boiling point, this is called
"Overheating" .
1. Stop the machine operation in a safe place and keep the engine
unloaded idling.
2. Don't stop the engine suddenly, but stop it after about 5 minutes
of unloaded idling.
3. Keep yourself well away from the machine for further 10
minutes or while the steam blown out.
4. Checking that there gets no danger such as burn, get rid of the
causes of overheating according to the manual, see
"TROUBLESHOOTING" section, and then start again the
engine.
9Y1210278GEG0028US0
Checking Intake Air Line
1. Check to see that hoses and hose clamps are tight and not
damaged.
2. If hoses and clamps are found worn or damaged, replace or
repair them at once.
9Y1210278GEG0029US0
Replacing Engine Oil Filter Cartridge
• Refer to G-16.
9Y1210278GEG0030US0
Changing Engine Oil
• Refer to G-16.
9Y1210278GEG0031US0
[6] CHECK POINTS OF EVERY 400 HOURS
Replacing Fuel Filter Element
• Refer to G-25.
9Y1210278GEG0032US0
Replacing Hydraulic Oil Filter
• Refer to G-17.
9Y1210278GEG0033US0
(1) Radiator Hose (2) Clamp
(1) Hose (2) Hose Clamp
KiSC issued 08, 2012 A