wsm Kubota L4100, Workshop Manual

Page: 219 / 346

BRAKES L4100, WSM
5-S5
(EU)
[2] PREPARATION
(1) Separating Rear Axle Case from Transmission Case
Draining Transmission Fluid
1. Place an oil pan underneath the transmission case.
2. Remove the drain plugs (1), (2).
3. Drain the transmission fluid.
4. Reinstall the drain plugs (1), (2).
(When refilling)
• Fill up new oil from the oil filling port (3) up to the upper line of
the oil level gauge (4).
• After running the engine for few minutes, stop it and check the
oil level again, add oil to prescribed level, if necessary.
IMPORTANT
• Use only multi-grade transmission fluid. Use of other fluids
may damage the transmission or hydraulic system.
Refer to "LUBRICANTS, FUEL AND COOLANT". (See page
G-9.)
• Never work the tractor immediately after changing the
transmission fluid. Keep the engine at medium speed for a
few minutes to prevent damage to the transmission.
• Do not mix different brands oil together.
9Y1210278ENS0109US0
Three Point Linkage and ROPS
1. Upper ROPS (1) with safety strap (2).
2. Remove check chains (8), top link (5), lift rods (6) and lower
links (7).
3. Remove the lower ROPS (4).
(When reassembling)
9Y1210278TRS0010US0
Transmission fluid Capacity
40.0 L
10.6 U.S.gals
8.80 Imp.gals
(1) Drain Plug
(2) Drain Plug
(3) Oil Filling Port
(4) Oil Level Gauge A: Oil level is acceptable within this
range.
Tightening torque
ROPS
mounting
screw
M14 screw
167 to 196 N·m
17.0 to 20.0 kgf·m
123 to 144 lbf·ft
M12 screw
78 to 90 N·m
7.9 to 9.2 kgf·m
58 to 66 lbf·ft
ROPS fulcrum screw
118 to 137 N·m
12.0 to 14.0 kgf·m
86.8 to 101 lbf·ft
(1) Upper ROPS
(2) Safety Strap
(3) ROPS Fulcrum Screw
(4) Lower ROPS (5) Top Link
(6) Lift Rod
(7) Lower Link
(8) Check Chain
KiSC issued 08, 2012 A