DigiReader Series
22 P/N 6600025, R
EV
. D
•
Connect the DigiReader interface cable to the controller wiring run according to Table 4. If the
DigiReader is the last S-Net device on the S-Net cable run, install the termination jumper as
directed on page 7
, 120 OHM TERMINATION JUMPER (INTERNAL/EXTERNAL)
, (Table 3).
•
Set the address switch, as required.
and as an alternative for the DR4208S,
open the notch for routing the cable
through the bottom of the DigiReader
The DR4203
cable is routed
through the
back only
For the DR4200K
W-E
strap
Strapping holes
on DR4208S
SW-NE strap
and the DR4205 and
DR4220 DigiReaders,
Drill a 1/4" diameter
hole in the appropri-
ate side of the facia
for the DR4205GM
only (See Figure 15,
for the location)
Figure 11: Cable Routing Configurations
Проектирование
.
Монтаж
.
Продажа
. - http://vskd.ru