13
o
The height must be adjusted prior to building the appliance into the housing unit and it should be set at
such a height that the top panel of the appliance fits exactly below the kitchen worktop.
o
The appliance height is 865mm when produced in factory,can adjust height from 865-920mm by adjusting
the feet.
o
Pull down the appliance carefully approximately 60° to allow access to the adjustable feet.
o
Take care to ensure the cooler is supported at all times.
o
Twist the foot into a suitable position to level the cooler from 870 to 920mm.
o
Repeat these steps for the other adjustable feet.
IMPORTANT: If the appliance is not level, then the door and door seal may be affected.
IMPORTANT: Do not move the appliance when the feet are adjusted high.
Installing the handle
o
Remove the door gasket on the side you wish to install the handle.
You can see two designated holes for handle installation.
o
Install the handle tightly as shown in the diagram above with the
two screws, lock washers and flat washers provided.
o
Replace the door gasket.
IMPORTANT: DO NOT HEAT THE DOOR SEAL ON ANYTHING BUT THE
LOWEST HEAT SETTING, OR HEAT THE SEAL FOR A LONG PERIOD OF TIME.
OTHERWISE DAMAGE MAY BE CAUSED TO THE DOOR SEAL, WHICH WOULD NOT BE RECTIFIED UNDER THE
GUARANTEE FREE OF CHARGE.
IMPORTANT: WHEN YOU HAVE REVERSED THE DOOR OF THE APPLIANCE, IF YOU HAVE
PLACED THE APPLIANCE ON ITS BACK, YOU MUST WAIT FOR 8 HOURS BEFORE SWITCHING
THE APPLIANCE BACK ON.
Troubleshooting
IMPORTANT: If your beverage cooler appears not to be operating properly, before contacting the Customer
Care Department, please refer to the checklist below.
