Page 5
WALL / SHALLOW BASE UNIT
150 - 600 Assembly Guide
WALL UNITS ONLY
for Shallow Base see pages 7 & 8
A
B
Step 14.
Secure corner gussets to the
bottom left and right hand side of
the wall unit using 4 x 15mm screws
(L)
per plate.
Step a
Insert hanging
bracket
into pre-drilled holes
Step c
Secure with provided
2 x 20mm screws
(S)
per bracket
Step b
Rotate locking
lever 180 degrees
Detail A
Detail A
S
S
Detail A
View through
Back Panel
Pilot
hol
e
M
Detail B
L
L
L
L
Detail B
Step 15.
Drill a small pilot hole through the centre of the corner gussets,
through the back of the unit. Use this hole at the end of the
process to screw through and into the wall. Cover the screw
heads using the cover caps
(M)
provided.
Screws for fixing to walls are not provided
as these vary
depending on your wall material and construction. Ensure
appropriate fixings for wall constructions are used.
Step 13.
Hanging Brackets steps a,b & c to be carried out on both sides as shown
Care to be taken. Hanging procedure is necessary for a safe installation.