background image

Page 2 

 

•  

Therabath

®

PRO

®

 Model TB4 (220-volt) Service Manual

Contents

General Operating Instructions ............................................................. 3
Technical Specifications .......................................................................... 3
Service Procedures .................................................................................. 3

Equipment Needed ............................................................................................... 3
Visual Inspection ................................................................................................... 4
Checking the Temperature of the Bath .............................................................. 4
Removing the Paraffin or Mineral Oil ............................................................... 5
Replacing the Snap Action Thermostat (S.A.S.) Assembly ............................ 7

Ordering Parts ......................................................................................... 8

List of Figures

Schematic/Wiring Diagram of 

Therabath

®

Pro

................................................................................

6

Bottom and Side Views of Inside 

Therabath

®

Pro

 Tank ............................... 7

Cross Section of Case Groove and Tank Lip ................................................... 8

Important Safeguards

— READ ALL INSTRUCTIONS BEFORE REPAIRING—

WARNING

• Repairs must be done by a qualified technician only.

Failure to properly repair this device may cause injury to the user.

This device must be repaired so that the bath maintains the temperature of the
paraffin between the temperature limits stated within this manual.

If the unit is repaired by anyone other than WR Medical Electronics Co. personnel,
all warranties are voided.

CAUTION

Because specialized equipment and techniques are required in order to properly re-
pair this product, we recommend that all units be returned to the factory for repair.

For repair advice, contact the factory service department at:
WR Medical Electronics Co.
123 North Second Street, Stillwater, MN 55082 USA
Phone: (651) 430-1200
FAX: (651) 439-9733
E-mail: [email protected]
Web Site: www.wrmed.com

Read all of these instructions before attempting to begin repairs.

The specifications in this manual are subject to change without notice.

— Save These Instructions —

Summary of Contents for Therabath Pro TB4









Reviews: