Product
Description
Designed for use with hoisting equipment, MRTA8-DC3 lifters support loads using vacuum and
manipulate loads using manual 360° rotation and mechanically assisted, manual 90° tilt motions.
Model Number
MRTA811LDC3
MRTA810TDC3
MRTA810CDC3O
Vacuum Pads
1
1...... Available with other rubber compounds for special purposes (see
).
(8 each, standard rubber)
11" [28 cm] nom. diameter,
lipped (Model G3370)
10" [25 cm] nom. diameter,
with ring (Model VPFS10T
2
2...... Standard with replaceable sealing rings for rough or textured surfaces (see
)
10" [25 cm] nom. diameter,
concave (Model G0750)
Pad Spread
3
3...... The illustrations under
show the Pad Spread and Maximum Load Capacity for all approved MRTA811LDC pad
frame configurations.
---------------------------- (to outer edges) ----------------------------
Length
‒
Maximum
104¾" [266 cm]
104" [264 cm]
102½" [260 cm]
Length
‒
Minimum
47" [119 cm]
46" [117 cm]
44¾" [114 cm]
Width
‒
Maximum
58¾" [149 cm]
58" [147 cm]
56½" [143 cm]
Width
‒
Minimum
12½" [32 cm]
11½" [29 cm]
10" [26 cm]
Maximum Load
Capacity
4
4...... The Maximum Load Capacity is rated at a vacuum of 16" Hg [-54 kPa] on clean, smooth, nonporous flat surfaces with a friction coefficient of 1. Pad
compound, load rigidity, strength, surface conditions, overhang, angle, center of gravity and temperature can also affect the lifting capacity. A “qualified
person” should evaluate the effective lifting capacity for each use (see definition under
Total with 4 Pads
320 kg
270 kg
270 kg
Total with 8 Pads
635 kg
545 kg
545 kg
Lifter
Weight
91 kg
87 kg
87 kg
Power System
12 volts DC, 5.5 amps
Battery Capacity
7 amp-hours
Rotation
Capability
Manual, 360°, with latching at each ¼ turn (when required)
Tilt
Capability
Manual, 90°, with four-bar tilt linkage that provides mechanical advantage and tilt locks that prevent tilt
motion when engaged
Product
Options
See separate instructions about options.
Operating
Elevation
Up to 6,000' [1,828 m]
Operating
Temperatures
32° — 104° F [0° — 40° C]
Service Life
20,000 lifting cycles, when used and maintained as intended
5
5...... Vacuum pads, filter elements and other wear-out items are excluded.
Software Version
Intelli-Grip
®
7.6
Design
Standard
Compliant with AS 4991. Note: Each circuit of the Dual Vacuum System complies with the capacity
requirements of this Standard.
Rev 5.0/2-21
MRTA8-DC3: #35121AUS
3
SPECIFICATIONS