Rev 1.0/2-17
2
#35204
INSTALLATION
Note: All screws not assembled with
a lock washer should be installed with
a thread locking compound, to
prevent them from loosening.
1) Identify all the components shown and make sure all are included with the Tilt Lock (except
those already existing).
2) Position all four tilt lock ramp plates (#3 & #11) in the appropriate orientations, as shown.
Then insert and tighten the 1/4-20 x 1/2" flat head screws (#4―three per plate). Note:
Vertical and horizontal ramp plates are identical.
3) Insert and tighten two 1/4" dia. x 5/16" shoulder screws (#2) in the tilt linkage bars, as
shown.
4) Insert the 3/8" dia. x 5/16" shoulder screw (#8/9) through the slot in the tilt lock catch plate
(#7), as shown.
Place a 3/8" ID flat washer (#6) over the protruding part of the shoulder screw, to lie flat
against the tilt lock catch plate as shown.
Align the shoulder screw and thread it into the corresponding threaded hole in the tilt linkage.
Then tighten the screw securely.
Repeat these steps to install and tighten the remaining three screws/flat washers that mount
the tilt lock catch plates onto the tilt linkage.
Note: In order for all four screws to properly align with the holes in the tilt linkage, the next
step may be required. Otherwise, proceed to step 6.
1
Originally designed as two separate parts (see illustration), these have now been combined into one shoulder screw.
1) TILT STOP CAM (vertical/existing)
2) 1/4" DIA. X 5/16" SHOULDER SCREW
3) TILT LOCK RAMP PLATE (vertical)
4) 1/4-20 X 1/2" FLAT-HEAD SCREW
5) SPRING W/MOUNTING RING
6) 3/8" ID FLAT WASHER
7) TILT LOCK CATCH PLATE
8/9) 3/8" DIA X 5/16" SHOULDER SCREW
1
10) 1/4-20 X 3/4" SOCKET-HEAD SCREW
11) TILT LOCK RAMP PLATE (horizontal)
12) TILT STOP CAM (horizontal/existing)
