4x1 Conference Tabletop Box with Soft Codec
12
l
Input Delay: Set the sending interval time between the “Display On” and “Display
Input Select” commands.
l
Display Input Select: Enter the “Display Input Select” RS232 command to be saved,
and then click “Save”. The command is usually used to select input source for the
display device.
l
No Activity Timeout: The system will enter standby mode, and the display device will
be automatically shut down when no any activity is detected within the setup time.
l
No Signal Timeout: The system will enter standby mode, and the display device will
be automatically shut down when no source signal is detected within the setup time.
6.3 EDID Tab
l
Click “HDMI 1”, “HDMI 2”, “USB-C”, “HDMI 3” or “RX HDMI” to select the source
device, and then select the desired built-in EDID for the selected source device.
l
User-defined 1/2: There are two user-defined EDID can be set by the following
steps:
ü
Step 1: Prepare the EDID file (.bin) on the control PC.
ü
Step 2: Select the “User-defined 1” or “User-defined 2”.
ü
Step 3: Select the EDID file (.bin) according the tooltip.
ü
Step 4: Click “Apply” to upload the user-defined EDID.