3x1 Conference Tabletop Box with Soft Codec
8
6.1.2 Display Control
l
Auto Display Control: Enable or disable the auto display control mode. In auto
display control mode, the unit will automatically perform the following operations.
ü
System On:
When the unit detects source signal input (5V or TMDS), or receives “Wake Up”
command, it will automatically perform the following operation steps:
1) Send “Display On” CEC command to the display device.
2) Send “Display On -> Delay Time (default: 10S) -> Display Input Select” RS232
commands to the display device.
ü
System Off:
When the unit detects no signal source input and the No Signal Timeout (default:
0S) is up; detects no activities or RS232 communication and No Activity Timeout
(default: 0min) is up; or receives “Power Off” command, it will automatically perform
the following operation steps:
1) Send “Display Off” CEC command to the display device.
2) Send “Display Off” RS232 command to the display device. This command is
sent once by default, or it can be sent twice by setting.
3) Only after executing “System Off” program, the “System On” can be triggered.
Note: The “Display On”, “Display Off” and “Display Input Select” RS232 commands;
the Delay Time, No Signal Timeout and No Activity Timeout can be set by GUI
