Worx WX646, Manual

Page: 6 / 76

Palm sander EN
7 6 PB 7
SYMBOLS OPERATING INSTRUCTIONS
NOTE:
Before using the tool, read the
instruction book carefully.
INTENDED USE
The machine is intended for dry sanding of
wood, plastic, filler and coated surfaces.
1. FITTING THE SANDING PAPER
(See Fig. A)
Fit the paper over the pad so that it covers
the entire area. Make sure the sanding paper
is even with the edges and that the dust
collection holes in the pad and sanding paper
is aligned and the sanding paper evenly
overlaps the pad. Never use your sander
without a sanding paper.
2. USING THE DUST ADAPTER (See Fig. B)
Your sander is equipped with a dust adapter,
which is designed for collecting dust task.
Insert the dust adapter into the rear dust outlet
of sander. Then pull the dust adapter and
make sure it is tightened securely on the dust
outlet. Then connect the hose of a vacuum
cleaner. First please turn on the vacuum
cleaner, then turn on the sander. If you stop
sanding, first turn off the sander, then turn off
your vacuum cleaner.
3. ON/OFF SWITCH
To start your sander, depress the protective
cover over the switch at the position
marked“I”. To stop your sander, depress the
protective cover at the position marked “0”.
4. FLUSH SANDING FACILITY
Your sander can sand flush on three sides of
the base-plate which allows easy access to
corners and edges of moulding.
5. ORBITAL SANDING
Your sander operates in small circular rotations
which allows efficient material removal.
Operate your sander in long sweeping
movements across your workpiece and even
across the grain. For a finer finish, always use
a fine grain sandpaper and only move the
sander in the direction of the grain and never
across the grain.
To reduce the risk of injury, user
must read instruction manual
Double insulation
Warning
Wear ear protection
Wear eye protection
Wear dust mask
Waste electrical products should
not be disposed of with household
waste. Please recycle where facilities
exist. Check with your Local Authority
or retailer for recycling advice.