Worx WX625, Original Instructions Manual

Page: 10 / 128

Perpendicular planer EN
11 10
OPERATING INSTRUCTIONS
NOTE:
Before using the tool, read the
instruction book carefully.
INTENDED USE
The machine is intended for planning of firmly
supported wooden materials, such as beams
and boards. It is also suitable for beveling
edges and rebating.
1. SAFETY ON/OFF SWITCH
The switch is locked off to prevent accidental
starting. Depress the lock off button (2) then
on/off switch (1) and release lock off button
(2). The machine is working now. To switch off
,just release the on/off switch. (See fig. A)
2. CUTTING DEPTH ADJUSTMENT
Smaller cutting depth of 0-1mm (Max. 2.0mm)
is best for most surface planning or rebating.
Rotate the cutting depth adjustment (4) to
set the required cutting depth on the scale,
Scale graduation = 0.125mm. The clockwise
rotation increases the planning depth;
the counterclockwise rotation reduces the
planning depth. (See fig. B)
3. ADJUST DUST EXTRACTION AND
CHIP EJECTION
Dust extraction can be adjusted to the right
or left side by manually. Rotate one end of
the dust extraction (5) until it stops (See fig.
C). The arrowhead on the dust extraction
indicates the dust extraction direction.
NOTE: Due to the size and material
of some wood shavings e.g. wet or
hard wood it is possible for the dust
extraction to become blocked. Remove
the plug from the mains power supply,
then using a wooden stick clear the
blocked dust extraction.
4. BASEPLATE STAND
Uplift the rear of the planer, the base plate
stand (6) can make the machine to be set
down directly and protect the cutting blades
from any damage and the blades from
damaging the surface (See fig. D). When
planning, the stand will be pushed away by
the end of the wood. Always check the stand is
free to move on the base plate (See fig. E).
5. BLADE FITTING AND CHANGING
WARNING: Remove power cord
from the socket before carrying out
any adjustments or changing blades.
The blade has two cutting edges, which can
be reversed .When replacing or reversing the
plane blades, the guide groove guarantees
constant height adjustment.
NOTE: Dull and worn blade cannot be
reground and must be replaced.
Remove the plug from the mains socket.
Using the spanner (19) provided loosen the
3 bolts approximately 1/2 rotation counter-
clockwise (See fig. f). Holding the blade
clamp (7) in position, using a piece of wood
slides the blade (8) out of the blade clamp (7)
to remove the blade from the blade clamp
(See fig. f)
NOTE: There is no need to remove the
blade clamp (7) as this can change the
factory settings for cutting blade height
control.
Before reinserting a new or reverse
blade, always clean both the blade and the
blade seat if dirty. Slide the blade into the
blade clamp in the correct orientation. Check
the blade is equal with the clamp. When
tightening the screws (10) ensure the correct
tightening sequence (
1
,
2
,
3
). Before
starting, rotate by hand to check the roller is
free to rotate.
Rotate the blade head by a further 180
o
and
repeat the procedure disassembling the
second plane blade.
6. REPLACING A DRIVE BELT
WARNING:
1) Remove the plug from the socket
before carrying out any adjustment,
servicing or maintenance.
2) The cutting blades will be turning and
may cause injury.
Loosen screw and remove belt cover (11),
remove worn drive belt from large pulley (13)
and pinion (12) and clean them (See fig. G).
Lace the new drive belt on the top of pinion
and turning it manually, press it on the large
pulley (13) (See fig. H).Make sure the drive