Worx WX572L, Owner'S Manual, Page: 15 / 32

BladeRunner
®
X2 EN
15
TROUBLE SHOOTING
Symptom Possible Causes Possible Solution
Tool will not start when
switched on. • Power cord is not
plugged in.
• Check to make sure power
cord is connected well into a
working outlet.
Poor cut quality
• Blade is worn out.
• Blade is set incorrectly
• Too much vibration
in material.
• Too much vibration
of the saw.
• Feed rate too fast.
• Make sure the blade is sharp and
not broken.
• Make sure the blade is
installed properly.
• Tighten Guard and Guard Arm
firmly down onto material.
• Clamp or fasten saw base
to tabletop.
• Feed the material more slowly.
Work efficiency is low.
• Blade is worn out.
• Feed rate too fast. • Change to a new blade.
• Feed the material more slowly.
Blade is not clamped tightly by
the Blade Holder. • Blade is not inserted into
place fully.
• Use blade grip to push the blade as
far into the blade holder as possible
before letting go of Blade Release.
Blade Release button cannot be
pressed down.
• Dust accumulates.
• Clean the dust around the Blade
Release button.
Guard Arm vibrates too much.
• Screws fixing the Guard
Arm on the work table are
loose.
• Tighten the screws as shown in
Fig A1.
Rip Fence cannot slide into
Fence Slot smoothly. • Rip Fence locking knob
too tight. • Loosen the Rip Fence
locking knob.