Circular saw
WX440
WORKING HINTS FOR YOUR
CIRCULAR SAW
If your power tool becomes too hot, run your circular
saw no load for 2-3 minutes to cool the motor. Avoid
prolonged usage at very low speeds.
Always use a blade suited to the material and material
thickness to be cut. The quality of cut will improve as
the number of blade teeth increase.
Always ensure the work-piece is firmly held or clamped
to prevent movement. Support large panels close to
the cut line. Any movement of the material may affect
the quality of the cut. The blade cuts on the upward
stroke and may chip the uppermost surface or edges of
your work piece. When cutting, ensure your uppermost
surface is a non-visible surface when your work is
finished. Feeding too fast significantly reduces the
performance of the machine and shortens the life of the
saw blade. Always face the good side of the work-piece
down, to ensure minimum splintering. Only use sharp
saw blades of the correct type.
MAINTENANCE
Remove the plug from the socket before carrying
out any adjustment, servicing or maintenance.
Your power tool requires no additional lubrication or
maintenance. There are no user serviceable parts in
your power tool. Never use water or chemical cleaners
to clean your power tool. Wipe clean with a dry cloth.
Always store your power tool in a dry place. Keep the
motor ventilation slots clean. Keep all working controls
free of dust. Occasionally you may see sparks through
the ventilation slots. This is normal and will not damage
your power tool.
If the supply cord is damaged, it must be replaced by
the manufacturer, its service agent or similarly qualified
persons in order to avoid a hazard.
TROUBLESHOOTING
1. If your power tool does not start, check the plug on
the power supply first.
2. If your power tool use in low efficiency, check the tool
speed and type of accessory.
3. If a fault can not be rectified, return the tool to an
authorized dealer for repair.
18
16
13
15
20
J
I
K