Worx WX290L, Owner'S Manual

Page: 11 / 28

20V Cordless Impact Driver EN
11
OPERATING INSTRUCTIONS
NOTE:
Before using the tool, read the
instruction book carefully.
ASSEMBLY AND OPERATION
ACTION FIGURE
BEFORE OPERATION
Removing the battery pack See Fig. A1
Charging the battery pack See Fig. A2
Installing the battery pack See Fig. A3
ASSEMBLY AND
ADJUSTMENT
Installing the screwdriver bit See Fig. B
Forward/Reverse/Lock
WARNING:
Never
change the direction
of rotation when the chuck
is rotating, wait until it is
stopped!
See Fig.
C1,C2,C3
OPERATION
Operating the On/Off Switch
WARNING:
Do not
operate for long
periods at low speed because
excess heat will be produced
internally.
See Fig. D
LED Light Indicator
WARNING:
To turn on
the light, press the On/
Off switch and make sure the
Forward/Reverse Rotation
Control is on right/left position.
The LED Light is also a battery
capacity indicator. It will flash
when power gets low.
See Fig. D
DISPOSAL OF AN
EXHAUSTED BATTERY PACK
Li-Ion
To preserve natural resources, please
recycle or dispose of the Battery Pack
(7) properly. This Battery Pack contains
Lithium batteries. Consult your local waste
authority for information regarding available
recycling and/or disposal options. Discharge
your Battery Pack by operating your drill, then
remove the Battery Pack from the drill housing
and cover the Battery Pack connections with
heavy-duty adhesive tape to prevent short
circuit and energy discharge. Do not attempt
to open or remove any of the components.
TROUBLESHOOTING
1. I CAN NOT FIT THE BATTERY INTO
THE BATTERY CHARGER. WHY?
The battery can be inserted into the charger
only in one direction. Turn the battery around
until it can be inserted into the slot.
2. REASONS FOR DIFFERENT BATTERY
PACK WORKING TIMES
Charging time problems, as above, and
having not used a Battery Pack for a prolonged
time will reduce the Battery Pack working time.
This can be corrected after several charge and
discharge operations by charging & working
with your drill. Heavy working conditions such
as large screws into hard wood will use up the
Battery Pack energy faster than lighter working
conditions. Do not re-charge your Battery Pack
below 32° F (0
o
C) and above 113° F (45
o
C) as
this will affect performance.
MAINTENANCE
Remove the battery pack from the tool
before carrying out any adjustment,
servicing or maintenance.
Your tool requires no additional lubrication or
maintenance.
There are no user serviceable parts in your
power tool. Never use water or chemical
cleaners to clean your power tool. Wipe clean
with a dry cloth. Always store your power tool
in a dry place. Keep the motor ventilation slots
clean. Keep all working controls free of dust.
Occasionally you may see sparks through the
ventilation slots. This is normal and will not
damage your power tool.