Worx WX253, Safety And Operating Manual

Page: 12 / 20

13 12
1
2
1
2
OPERATING INSTRUCTIONS
NOTE:
Before using the tool, read the instruction book
carefully.
INTENDED USE
The power tool is intended for driving in and loosening screws
as well as for drilling in wood, metal and plastic.
BEFORE OPERATING THIS TOOL
A) CHARGE THE BATTERY
The battery charger supplied is only for the Li-Ion battery
installed in the machine. Do not use another battery charger.
The Li-Ion battery is protected again st deep discharging. When
the battery is empty, the machine is switched off by means of a
protective circuit: The tool holder no longer rotates.
When the Battery Pack is charged for the first time or after
prolonged storage, the Battery Pack will accept a 100% charge
after several charge and discharge cycles.
B) CHARGING (See Fig. A)
Plug the charger plug into a suitable power outlet. Next, connect
the screwdriver to the Charging Socket; the indicator will
illuminate Red during charging.
Let the battery charge for 3-5 hours. The battery is fully charged
as soon as the indicator is no longer lit. Then unplug the
charging, Disconnect the Charger from the screwdriver. The
screwdriver is ready to be used.
IMPORTANT:
When charging, the charger and screwdriver may
become warm to the touch; this is normal and does not indicate
a problem.
A
1
2
1
2
B