Worx WU533, Manual, Page: 14 / 24

14
EN
ACCESSORY
WU533 WU533.1 WU533.9
Hex key 1 1 1
Woodworking saw
blade
1 1 1
Strap 1 1 1
Parallel guide / 1 /
4.0Ah Battery
pack(WA3016)
2 2 /
2.0A Charger
(WA3924)
1 / /
6.0A Charger
(WA3922)
/ 1 /
We recommend that you purchase your accessories
from the same store that sold you the tool. Refer to
the accessory packaging for further details. Store
personnel can assist you and offer advice.
OPERATING INSTRUCTIONS
NOTE:
Before using the tool, read the
instruction book carefully.
WARNING:
Do not release the handle until
Do not release the handle until the saw blade
come to complete stop and do not touch saw
blade while the saw blade is running.
Intended use:
The tool is intended for ripping
and cross-cutting wood and other materials in
straight cutting lines, while resting firmly on
the work piece.
ASSEMBLY AND OPERATION
ACTION FIGURE
BEFORE OPERATION
Removing the battery pack See Fig. A1
Charging the battery See Fig. A2
Installing the battery pack See Fig. A3
ASSEMBLY
Mounting and Removing the
Blade
NOTE:
Lock or loose the blade
bolt, the spindle lock button
should be pressed.
WARNING: Always
remove the battery
before changing the blade!
See Fig. B
Safety switch and On/Off
trigger
WARNING:
To avoid
cutting injury from the
sharp blade, please don’t put
your hands around the Base
Plate.
NOTE:
Keep the dust adapter
connected to dust collecting
device when using the tool.
See Fig. C
Rip and Cross Cutting
NOTE:
The cutting line of
saw blade is aligned with the
cutting mark 0°.
See Fig. D1, D2
Parallel Guide See Fig. E1, E2
Adjusting the Cutting Depth See Fig. F1, F2
Adjusting the Cutting Angle
NOTE:
The cutting line of
saw blade is aligned with the
cutting mark 45°.
See Fig. G
Pocket /Plunge See Fig. H1, H2
WORKING HINTS FOR YOUR
TOOL
If your power tool becomes too hot, please run your
circular saw no load for 2-3 minutes to cool the
motor. Avoid prolonged usage at very low speeds.
Protect saw blades against impact and shock.
Cutting with extreme force can significantly
reduces the performance capability of the tool and
reduces the service life of the saw blade. Sawing
performance and cutting quality depend essentially
on the condition and the tooth count of the saw
blade. Therefore, use only sharp saw blades that are
suited for the material being cut.
Choice of blades: 24 teeth for general work, approx.
40 teeth for finer cuts, more than 40 teeth for very
fine cuts into delicate surfaces, diamond for tile,
cement board, etc.
Only use saw blades recommended.