10
lever (3) to the right for reverse rotation “
“.
Warning: Never change the direction of rotation while the
tool is rotating, wait until it has stopped.
ADJUsTABLe DePTH sTOP
Fit the drill bit into the chuck. Loosen the depth stop by rotating
the handle anti-clockwise. Slide the depth stop until the distance
between the depth stop end and the drill bit end is equal to the depth
of hole/screw you wish to make. Then clamp the depth stop by
rotating the handle clockwise.
FUNCTION MODe seLeCTION (see Fig. F & G)
The operation of the gearbox for each application is set with the
function mode selection switch (4), To change between functions,
depress the unlocking button (15) and rotate the selector to the
desired operating mode.
WU330 WU330L
WU330.1 WU330.2
WU330.3
WU332
WU332.1
For simultaneous drilling
and impacting of concrete
or masonry, choose the
Hammer drilling position.
For drilling into steel,
wood and plastics choose
the Rotary drilling position.
10
11
For impacting only
- for light chipping,
chiseling and demolition
applications choose the
Hammer position.
Warning: The operating mode selector switch may be
actuated only at a standstill.
Warning: Prolonged use will cause the aluminum housing
to become hot, do not touch.
Working hints for your drill
(hammer)
If your power tool becomes over heated, set the speed to maximum
and run no load for 2-3 minutes to cool the motor. SDS-plus tungsten
carbide drill bits should always be used for concrete and masonry.
When drilling in metal, only use HSS drill bits in good condition.
Always use a magnetic bit holder when using short screwdriver bits.
Where possible use a pilot hole before drilling a large diameter hole.
Maintenance
Remove the plug from the socket before carrying out any
adjustment, servicing or maintenance.
Your power tool requires no additional lubrication or maintenance.
There are no user serviceable parts in your power tool. Never use
water or chemical cleaners to clean your power tool. Wipe clean with
