Worx WG789, User Manual

Page: 16 / 52

Cordless self-propelled lawn mower EN
17 16 17 16
4) The safety guard is spring loaded.
When you release it, the guard will
return to the closed position.
4. iNSTalliNg mUlChiNg
PlUg (See k2)
1) Turn the mower off, wait until the blade
stops and remove the safety key.
2) Raise the safety guard and hold it up.
3) Slide the mulching plug (12) into
the discharge opening until it is
firmly in contact with the deck.
4) Release safety guard and ensure
it is properly closed.
5. CUTTiNg modE dial
SElECTioN (See l)
QUiET modE
Select QUIET mode (17) when mowing
in everyday conditions, removing
approximately 1 inch of grass at a time.
PowEr modE
Set the dial to POWER mode (17) when
cutting dense or overgrown grass.
6. iNSTalliNg SidE-diSChargE
ChUTE (See m1 & m2)
Using the mulching insert and side-
discharge chute (13), the grass can be
discharged from the side of the machine.
To assemble the side-discharge insert, raise
the side-discharge cover (9) and hold it up,
position the side-discharge chute (13) onto
the hooks, then release the cover to lock
the side-discharge insert into position.
7. PaCESETTEr
Tm
SElF-ProPEl
drivE (See N1 & N2)
To operate the self-propel drive, squeeze
the Safety bail (2) toward the handle
and hold it, and then push both the
handle and the Safety bail (2).
To disengage the self-propel drive,
release the safety bail (2).
NoTE:
The Pacesetter™ drive system
with rear wheel drive, automatically sets
the pace based on the operators walking
speed. Walk faster and the mower self
propels faster to match your pace.
NoTE:
The Pacesetter™ drive
system will operate with or without
the mower blade turned on.
8. mowiNg TiPS
NoTE: always inspect area where
mower is to be used and remove
all stones, sticks, wire, metal
and other debris which might be
thrown by the rotating blade.
1) Mow across the face of slopes, never
up-and-down. Exercise extreme caution
when changing direction on slopes. Do
not mow excessively steep slopes. Always
maintain good footing and balance.
2) Release safety bail to turn the mower
“OFF” when crossing any graveled area
(stones can be thrown by the blade).
3) Set mower at highest cutting height
when mowing on rough ground or
in tall weeds. Removing too much
grass at one time can cause circuit
breaker to trip, which stops mower.
4) If a grass bag is used during the fast
growing season, the grass may tend to
clog up at the discharge opening. Release
switch lever to turn mower “OFF” and
remove the safety key. Remove the grass
bag and shake the grass down to the back
end of the bag. Also clean out any grass
or debris which may be packed around the
discharge opening. Replace the grass bag.
5) If mower should start to vibrate
abnormally, release safety bail to turn
mower “OFF” and remove safety key.
Check immediately for cause of vibration.
Vibration is usually a warning sign of
trouble. Do not operate mower until
a service check has been made.
6) ALWAYS RELEASE SAFETY BAIL TO
TURN MOWER “OFF” AND REMOVE
SAFETY KEY WHEN LEAVING IT
UNATTENDED FOR ANY PERIOD OF TIME.
9. mUlChiNg mowiNg TiPS
While mulching, your new mower is
designed to cut the grass clippings into
small pieces and distribute them back into
the lawn. Under normal conditions, the
mulched grass will biodegrade quickly