Worx WG750, Manual

Page: 18 / 19

40V Cordless Lawn Mower EN
18
TROUBLE SHOOTING
Problem Solution
1. Mower
doesn’t run
when switch
lever is
activated.
A. Check to make sure safety key
has been installed and is fully
seated and that button on switch
housing is being completely
pushed.
B. Release Switch Lever to turn
mower off. Remove safety key,
turn mower over and check that
blade is free to turn. If not free,
return to an authorized servicer.
Blade should turn freely.
C. Has battery been fully
charged? Plug in charger and
wait for green light to come on.
2. Motor stops
while mowing.
A. Release Switch Lever to turn
mower off. Remove safety key,
turn mower over and check that
blade is free to turn. If not free,
return to an authorized servicer.
Blade should turn freely.
B. Raise cutting height of wheels
to highest position and start
mower.
C. Has battery been fully charged?
Plug in charger and wait for green
light to come on.
D. Avoid overloading the mower.
Slow down the cutting pace by
pushing mower slower or raise the
cut height. Or both.
3. Mower runs
but cutting
performance is
unsatisfactory,
or does not cut
entire lawn.
A. Has battery been fully
charged? Plug in charger and
wait for green light to come on.
B. Release Switch Lever to turn
mower off. Remove safety key.
Turn mower over and check:
Blade for sharpness - Keep blade
sharp. Deck and discharge chute
for clogging.
C. Wheel height adjustment
may be set too low for grass
condition. Raise cutting height.
4. Mower is
too hard to
push.
A. Raise cutting height to reduce
deck drag on grass. Check each
wheel for free rotation.
5. Mower is
abnormally
noisy and
vibrates.
A. Release Switch Lever to
turn mower off. Remove safety
key. Turn mower on side and
check blade to ensure it has
not been bent or damaged.
If blade is damaged, replace
with a replacement blade. If
the underside of the deck is
damaged return mower to an
Authorized service center.
B. If there is no visible damage
to the blade and the mower still
vibrates: Release Switch Lever to
turn mower off, remove safety
key and remove blade. Rotate
blade 180 degrees and retighten.
If mower still vibrates, return the
mower to an authorized service
center.
6. Battery
charger LED’s
not on.
A. Check plug connection.
B. Replace charger.
7. Battery
charger LED
does not flip to
green.
A. Battery needs to be
diagnosed. Take to authorized
service center.
8. Mower
not picking
up clippings
with the Grass
Collection Bag.
A. Remove mulch plate when
bagging.
B. Chute clogged. Release Switch
Lever to turn mower off. Remove
safety key. Clear chute of grass
clippings.
C. Too much cut grass. Raise
cutting height of wheels to
shorten length of the cut.
D. Bag full. Empty bag more
often.
9. When
mulching there
are clippings
visible.
A. Too much cut grass. Raise
cutting height of wheels to
shorten length of the cut. Do
not cut off more than 1/3 of total
length.
B. Check blade for sharpness.
Always keep blade sharp.
10. Low or
diminished
run-time after
many uses
A. Return to Authorized Service
location - may need new battery.