Cordless Hedge Trimmer
WG284E WG284E.X
11
workpiece is processed dependant on the following
examples and other variations on how the tool is
used:
How the tool is used and the materials being cut or
drilled.
The tool being in good condition and well maintained.
The use of the correct accessory for the tool and
ensuring it is sharp and in good condition.
The tightness of the grip on the handles and if any
anti vibration and noise accessories are used.
And the tool is being used as intended by its design
and these instructions.
This tool may cause hand-arm vibration
syndrome if its use is not adequately managed.
WARNING:
To be accurate, an estimation of
exposure level in the actual conditions of use
should also take account of all parts of the operating
cycle such as the times when the tool is switched off
and when it is running idle but not actually doing the
job. This may significantly reduce the exposure level
over the total working period.
Helping to minimise your vibration and noise
exposure risk.
Always use sharp chisels, drills and blades.
Maintain this tool in accordance with these
instructions and keep well lubricated (where
appropriate).
If the tool is to be used regularly then invest in anti
vibration and noise accessories.
Plan your work schedule to spread any high vibration
tool use across a number of days.
4. OPERATING
INSTRUCTIONS
NOTE:
Before using the tool, read the
instruction book carefully.
Intended use
The machine is intended for cutting and trimming
hedges and bushes in domestic use.
WARNING! Do not use the product without
attaching the guard and front handle.
ASSEMBLY & OPERATION
ACTION
FIGURE
BEFORE USING YOUR CORDLESS
HEDGETRIMMER
Assembling the safety guard
See Fig. A
Assembling the front handle
NOTE :
The handle is designed to
prevent being assembled in wrong
direction . If you find it cannot be
installed, please turn it around.
See Fig.
B1, B2
Checking the battery charge
condition
NOTE :
Fig. C only applies for the
battery pack with battery indicator
light.
See Fig. C
Charging the battery pack
NOTE :
• The batteries are shipped
uncharged. Each battery must be
fully charged before the first use.
• Always fully charge the two
batteries at same time. More
details can be found in charger’s
manual.
See Fig. D
Installing and Removing the battery
pack
NOTE :
• This machine will only
run when 2 batteries are
installed. It is recommended
to use the same two batteries
and charge the two batteries
at the same time.
• When you use two batteries
with different power, the
machine will only run to the
lower common denominator.
See Fig. E
OPERATION
Remove the blade sheath
See Fig. F
Starting and stopping
See Fig.
G1, G2
Rotating rear handle
NOTE :
•
Unlock the locking switch before
rotating.
•
After rotating the handle to the
desired position, adjust it a little
until a click can be heard.
WARNING:
• Always make sure that the
handle is locked in the desired
position before operation.
• Always make sure the locking
switch is locked before starting
the hedge trimmer.
See Fig.
H1, H2
